[Sam Oliver]

Good luck @Sam Oliver ! You'll get her done. Don't worry, you won't have any issues with your account here lol. At least, they'll be short-lived if you do. I'm looking forward to seeing your progress here and it can all be documented within this thread!

Also, let me know if you want replies to be disabled for this thread and I'll do that for you. (Some people might prefer a clean canvas to document their builds on, others might want commentary in-between).

I'd prefer to get commentary.   I have a little MS Access Database I'm working on in conjunction with the build for my build documentation purposes.


 Right now I'm working on finishing up items on the TailBoom Section of the Building guide.   On my RotorX Phoenix kit, Vertical fin installation was where I left of, while I was waiting on the actual vertical fin.   One of many many items not shipped when it was supposed to be.   My little metal bending station is too far away from the project.   Heat, bend, check fit, is not working.   My welding/metal working area of my shop is outside in a covered shed and the helicopter build is going on inside my shop.   So I'm going to move the Gas welding rig inside so I can do my bending and test fitting more effectively.   Heck, I may be able to get it done today.