02-17-2026, 02:44 PM
(Edited 02-17-2026, 05:05 PM by Claude Parent.)
Yes, the sensors are mounted in the same position as per Rotorway pictures. I agree with Homer's comment about the weight, I do have the Rotorway polar charts and looked at the the suggested solution of .5g by plotting the .180 in/s @ 269.6, what I am confused about is the difference between the polar chart and the system solution of "maybe"??? lagging the master blade by .090!
looking at the Rotorway polar chart, there is no solution that requires a change of lead/lag when the imbalance is at 90 or 270 degrees and in my case 269.6 .
I am using a Rotorway group file in the balancer however, I did not enter the variables in that group file. I was hoping someone with this DSS system experience could walk me through some of the settings and details on how to decipher and apply the suggested solutions.
I was reading through the Rotorway Notes on balancing again and I will go back to the start by doing a new Lead/Lag and static balancing adjustment as per the notes and take another balancer reading and see how it compares with my last results.
looking at the Rotorway polar chart, there is no solution that requires a change of lead/lag when the imbalance is at 90 or 270 degrees and in my case 269.6 .
I am using a Rotorway group file in the balancer however, I did not enter the variables in that group file. I was hoping someone with this DSS system experience could walk me through some of the settings and details on how to decipher and apply the suggested solutions.
I was reading through the Rotorway Notes on balancing again and I will go back to the start by doing a new Lead/Lag and static balancing adjustment as per the notes and take another balancer reading and see how it compares with my last results.