Cog Belt Tensioner

[Sam Oliver]

Looking for a little help from the experts or people who have experience with this later version Cog Belt Tensioner.   

 I'm building an A600 from two incomplete kits.   The construction factory videos are made with a much earlier setup so they don't help.   The factory construction manual, specifically Section 15 dated Jan 2017 Page 4, Photo #5 starts the process by asking me to refer to Print E49-8600 and card E49 Card 3T, which I do not have (did not come with my set of documents when I purchased this kit from RotorX prior to them folding.   I appear to have the actual parts, minus the "Tension relief block tool (E49-8681) that are shown in the construction manual.   

Does anybody have a pdf or photo of the construction card and factory drawing the instructions referenced--Print E49-8600 and card E49 Card 3T?
A photo of the tension relief block tool along side a ruler would help.  If it's just an installation tool, Maybe something I could fabricate?

Thanks
Sam

[Geno Mancini]

This may help.

  E49-8600 REV C.pdf (Size: 178.42 KB / Downloads: 23)

  CogBeldDrive.pdf (Size: 3.48 MB / Downloads: 21)

[Sam Oliver]

Thanks Geno.  This will help.

Sam

[Homer Bell]

It’s just a U shaped block that keeps the thing in the disengaged position while you’re installing it. It’s 1 to 1 1/8” long

[Sam Oliver]

Thanks Homer.